Styrax manufacturers fully featured micro controller based
PID105 controllers. It receives two universal inputs which can be
programmed in the factory. PID controller interface with BMS
through RS485 using standard MODBUS RTU. User can
configure set points through RS485 and also monitor Output
signal level and Input parameter values.
PID105 supports Auto
and Manual mode controlling. PID105 is an auto-tuning controller;
from cold start or at set point. Typical applications are temperature
control, RH control, thyristorised heating applications, AHU
control in HVAC and BMS applications.
- Advanced Microcontroller based PID controller.
- PID controlling.
- Software Calibration for 2 channels.
- Auto and Manual mode controlling.
- MODBUS RTU multi drop RS-485 serial communication for PLC, SCADA, etc.
- Fixed baud rate with 9.6k
- Remote programmable from master device.
- Wall mounting.
- ABS enclosure.
- %RH: 0.0 to 100% RH.
- Temperature: 0°C to 50°C.
- %RH: ±2% RH for 10 to 90% and ±3% RH for remaining.
- Temperature: ±0.3°C for 0°C to 50°C.
- %RH: 0.1% RH.
- Temperature: 0.1°C.